back to list

Arctic Butterfly® SD800 - Sensor Loupe® Combo

'Dry' Cleaning Method

Spin the brush to recharge the bristles and remove any previous debris. After recharging bristles, insert brush width to width of sensor.
Rotate and gently rest bristles on far edge of sensor. Lightly draw the bristles over the width of sensor.
Do not apply too much pressure. Lift from sensor, rotate brush width to width of sensor and remove.
Spin the brush to remove any debris that has been collected.

Arctic Butterfly® SD 800 Pro Kit


Note: Please refer to the video at the bottom of this page if your bristles are misshapen
Warning: Do Not Spin Device While Working Inside Camera Chamber

 

Includes:
  1. Arctic Butterfly® 800 w/ APS Size Sensor Brush
  2. 1.6x Size Sensor Brush (thick)
  3. 1.0x-1.3x Size Sensor Brush
  4. Angled Mirror/Focusing Screen Brush
  5. One-Size-Fits-All Brush Adapter
  1. Requires two (2) AAA batteries (not included). Use high qualities batteries for best performance. Remove the batteries before traveling, especially on a plane.

  2. Only use the sensor brushes on the sensor.

  3. Only use the mirror/focusing screen brush on the mirror and focusing screen.

  4. Be careful to not touch the sides of the chamber with any of the brushes so as to not contaminate them with oil or lubricant.

  5. Unscrew cap.

  6. Spin device by sliding the on button. Spin for 5 seconds to enhance charge prior to every pass.

  7. Carefully pass the bristles over your sensor/mirror/focusing screen from one side to another.

  8. Repeat as many times as needed.

  9. It is recommended to clean the brush fibers frequently with isopropyl alcohol (90% -99%) or VisibleDust Brush Wash Tablets™. This should specially be done if the fibers have been in contact with any oil or lubricant. To remove the smear from the sensor, it is recommended that VisibleDust Ultra MXD-100™ (green) swabs and Smear Away™ be used to remove the stain. VDust Plus™ can also be used for lighter stains.

The base of the Arctic Butterfly® 724 is to be used as the spinning device for all the other brushes. Simply remove the APS brush, place in the adapter and insert the desired brush.